Cable trays can be used for parallel lines

When connecting multiple conductors in parallel within cable trays, all conductors of the parallel set must be connected together, arranged correctly, and installed to ensure balanced current distribution and prevent overheating.Key PrinciplesBalanced Current Distribution: When multiple cables are used in parallel for a single phase, it is essential that the current is evenly distributed among all conductors. Imbalanced currents can lead to overheating, deformation of insulation, and reduced cable lifespan, potentially causing operational failures and additional maintenance costs (Prysmian) . Phase Sequence and Cable Arrangement: Proper phase sequencing and cable arrangement are critical. The magnetic field interactions and impedance differences between parallel cables can affect current distribution. Following international standards and regulations, such as IEC 60364-5-52 and Electrical High Current Facilities Regulation, ensures that parallel cables carry equal current and operate safely (Prysmian) . NEC Requirements: According to the 2020 NEC Section 300.3(B)(1), connections, taps, or extensions made from paralleled conductors must connect to all conductors of the parallel set, both grounded and ungrounded. This ensures that no single conductor is overloaded, as individual conductors are typically not rated to carry the full current of the overcurrent device (Electrical License Renewal) . Parallel runs in cable trays must comply with NEC 392.20(C).Installation Considerations in Cable TraysTray Selection and Spacing: Cable trays should provide adequate support and spacing to prevent mechanical stress and allow heat dissipation. Ventilated or solid-bottom trays can be used depending on heat generation and environmental conditions. Proper tray material selection (steel, aluminum, or stainless steel) ensures mechanical strength and corrosion resistance (ABB, Legrand) . Segregation and EMC: Different types of cables (power, control, instrumentation) should be segregated within trays to reduce electromagnetic interference and maintain safety. Following good EMC practices ensures reliable operation of sensitive equipment (ITER Cabling Handbook) . Mechanical and Thermal Management: Maintain minimum bend radii, avoid overcrowding, and ensure uniform spacing to prevent localized heating. Overheating can deform insulation and reduce cable life, so careful planning of cable layout and parallel conductor placement is essential (Prysmian, ABB) .SummaryTo safely implement parallel connections in cable trays:Connect all conductors of a parallel set together for taps or extensions.Ensure proper phase sequence and cable arrangement to balance currents.Use appropriate cable trays with adequate spacing, support, and material selection.Segregate different cable types to minimize electromagnetic interference.Follow NEC, IEC, and local regulations to ensure compliance and safety. By adhering to these principles, parallel cable installations in trays can operate efficiently, safely, and with minimal risk of overheating or failure.